Level Probe wiring on Black water and fresh water tank.

Cabinets, Woodwork, flooring ideas Wall panels etc.
Post Reply
Author
Message
Offline
Site Admin
Site Admin
Posts: 1233
Joined: Wed Nov 19, 2014 2:26 pm
Travco Model: 76 Mahal 2+2
Location: Arnoldsville GA
Contact:

Level Probe wiring on Black water and fresh water tank.

Unread post by KB2CRK » Wed Mar 11, 2015 10:43 am

Does anyone know the wiring on the level probes for the black water tank? My black water tank was not wired up when I pulled it out so I have no idea what goes where. If someone knows it would save me a lot of time trying to check one wire combo at a time. The fresh water tank is also unwired but at least there the left the ends of the wires connected to the tank so I have something to go by.\nAny help is greatly appreciated.\n\n\nThanks \nPaul

Offline
Moderator
Moderator
Posts: 1199
Joined: Sat Jan 26, 2013 2:32 am
Travco Model:
Location: Kerrville, Texas

Re: Level Probe wiring on Black water and fresh water tank.

Unread post by 77Travco » Fri Mar 13, 2015 10:59 am

All I can offer is an old picture of my blackwater tank. (see below) I doubt it will help you much though.
You do not have the required permissions to view the files attached to this post.

Offline
Site Admin
Site Admin
Posts: 1233
Joined: Wed Nov 19, 2014 2:26 pm
Travco Model: 76 Mahal 2+2
Location: Arnoldsville GA
Contact:

Re: Level Probe wiring on Black water and fresh water tank.

Unread post by KB2CRK » Fri Mar 13, 2015 2:58 pm

That works quite well. \nIt should be about the same from 76 to 77.\nThank you very much

Offline
Site Admin
Site Admin
Posts: 1782
Joined: Tue Jan 22, 2013 7:01 am
Travco Model: 1975 270,1974 220
Location: North East Ct

Re: Level Probe wiring on Black water and fresh water tank.

Unread post by Acesneights » Sat Mar 14, 2015 7:00 pm

I have owned several Travcos and yet to see one work so don't get your hopes up.. :mrgreen:\nThat pic is different than the ones I have had though.
1977 Travco 270 Elite\n1974 Travco 220 Parts unit

Offline
Senior Contributor
Senior Contributor
Posts: 629
Joined: Fri Feb 21, 2014 10:32 am
Travco Model: 270
Location: Ohio

Re: Level Probe wiring on Black water and fresh water tank.

Unread post by badbillybiker » Sun Mar 15, 2015 8:13 pm

wouldn't it be feasible or should I say practical to just buy a new fluid level kit and be in total control of the level readings?\nLooking for opinions and options to get around poor or non working gauges and available kits..\nBBB

Offline
Site Admin
Site Admin
Posts: 1233
Joined: Wed Nov 19, 2014 2:26 pm
Travco Model: 76 Mahal 2+2
Location: Arnoldsville GA
Contact:

Re: Level Probe wiring on Black water and fresh water tank.

Unread post by KB2CRK » Sun Mar 15, 2015 8:42 pm

My tank is different but that is the same probe set up.

Offline
Moderator
Moderator
Posts: 1199
Joined: Sat Jan 26, 2013 2:32 am
Travco Model:
Location: Kerrville, Texas

Re: Level Probe wiring on Black water and fresh water tank.

Unread post by 77Travco » Mon Mar 16, 2015 10:15 am

Just for the record... both of my holding tank level indicators work. knock on wood.

Offline
Site Admin
Site Admin
Posts: 1233
Joined: Wed Nov 19, 2014 2:26 pm
Travco Model: 76 Mahal 2+2
Location: Arnoldsville GA
Contact:

Re: Level Probe wiring on Black water and fresh water tank.

Unread post by KB2CRK » Mon Mar 16, 2015 10:51 am

Considering I have the same probe setup it should work when I reconnect them. I will be putting the tank back in in a few minutes...\nThanks again 77.

Post Reply

Return to “All other interior”